C2E FASSACOL EASYLIGHT S2 adhesive cement
Single-component, white, cement-based adhesive for exterior and interior flooring and cladding.
Features
Use
FASSACOL EASYLIGHT S2 is used to bond ceramics of all types such as clinker, single-fired, double-fired, terracotta, porcelain stoneware, even thin-thick slabs.
Also suitable for gluing mosaics of both ceramic and glass material (white version), composite materials based on cement and natural stones, not sensitive to stains and stable to humidity.
It is suitable for laying coatings of any size and thickness both indoors and outdoors.
The surfaces can be: lime-based render, cement, plaster and bastard mortars, well-cured and dry cementitious or anhydrite-based screeds, well-cured concrete slabs, laminated plasterboards, cementitious membranes, existing flooring (ceramic, marble, parquet, etc.), marine plywood, plywood and wood chipboards with low water absorption and stable.
Suitable for installation in plasters and screeds with a heating/cooling system, in FASSATHERM exterior thermal insulation systems, swimming pools, exterior facades, rooftops and, in general, for environments with high mechanical, thermal and vibration stresses.
Highly indicated for, taking into account the perfect compatibility of the materials, screeds SA 500, E 439, SV 472, SV 472 P, SR 450, LEGEO MIX, FASSAFLOOR THERM, screeds made with FASSACEM binder, waterproofing from the AQUAZIP line and plates of GYPSOTECH laminated plaster.
Preparation and application
Pour the contents of a bag into a bucket with clean water, respecting the quantity indicated in the Technical Data (36-38%) and mix with a low-speed mechanical stirrer for no more than 3 minutes, until obtaining a fluid, homogeneous and free mixture. lumps. Wait 5 minutes before application. Mix again and apply the adhesive with a notched trowel suitable for the type of tile to be glued. In any case, during application, make a first thin layer with the smooth side of the trowel, pressing vigorously to obtain maximum adhesion to the support. Adding too much water does not improve the workability of the adhesive, but can create several problems and reduce the final performance of the product. The mixture thus obtained will be workable for around 6 hours under normal temperature and humidity conditions; Under unfavorable conditions, the duration of the mixture may change. It is not necessary to wet the tiles before laying them, wash them with water only if the reverse side is very dusty. The tiles are applied using a slight pressure movement and tapping them properly, ensuring that the entire surface is in perfect contact with the adhesive. Any leveling must be carried out a maximum of 30 minutes after application. If a film forms on the surface of the adhesive, do not wet the surface, but use the notched trowel again. Depending on the characteristics of the tile (weight and format) and the thickness of the adhesive applied, to facilitate installation, the use of Fassa Bortolo levelers (NEW LEVEL TILE Kit) is recommended. In accordance with the UNI 11493-1 installation standard, when necessary, adopt the double gluing technique, that is, the creation of a "full bed" of adhesive.