| PARA ENVÍOS FUERA DE MURCIA Ó ALICANTE, CONTACTAR POR TELÉFONO |
High-performance white or gray single-component adhesive without vertical slip, with a long open time, good elasticity and deformable for interior and exterior flooring and cladding.
FASSAFLEX is applied indoors and outdoors on walls and floors, for laying: ceramic tiles, ceramic mosaic, clinker, stoneware, porcelain stoneware, cement-based compounds, natural stone that is not sensitive to stains and is stable to humidity.
The surfaces can be: lime, cement, gypsum-based plasters, mixed mortars, well-hardened and dry cement-based or anhydrite-based screeds, well-cured concrete screeds, gypsum plasterboard, existing flooring.
Suitable to be applied in renderings and screeds with heating/cooling systems, in SATE thermal insulation systems and swimming pools.
Highly indicated for, taking into account the perfect compatibility of the materials, SV 472 and SR 450 screeds, screeds made with FASSACEM binder, waterproofing from the AQUAZIP line and GYPSOTECH laminated gypsum boards.
Add 26-28% of clean water and mix by hand or with a mechanical mixer until a homogeneous mixture is obtained, without lumps and of the desired consistency. Wait 5 minutes before applying. Mix again and apply the adhesive with a notched trowel suitable for the type of tile to be glued.
Adding too much water does not improve the workability of the adhesive, but it can create various problems and reduce the final performance of the product. The mixture thus obtained will be workable for about 4 hours under normal conditions of temperature and humidity; in unfavorable conditions, the duration of the mixture may change.
The tiles are applied using a slight pressure movement and hitting them properly, making sure that the entire surface is in perfect contact with the adhesive. It is not necessary to wet the tiles before laying them, wash them with water only if the back is very dusty. The tiles are applied using a slight pressure movement and hitting them properly, making sure that the entire surface is in perfect contact with the adhesive. Any leveling must be carried out no later than 30 minutes after application.
If a film forms on the surface of the adhesive, do not wet the surface, instead pass the notched trowel again.
Depending on the characteristics of the tile (weight and format) and the thickness of the applied adhesive, to facilitate installation, the use of Fassa Bortolo levelers (NEW LEVEL TILE Kit) is recommended. In accordance with local laying regulations or when necessary, adopt the double-glue technique, i.e. the creation of a "full bed" of adhesive.
High-performance white or gray single-component adhesive without vertical slip, with a long open time, good elasticity and deformable for interior and exterior flooring and cladding.
